Troubleshooting discussion is based on the PCR protocol as described in the table below. All reactions are run for 30 cycles.
* The 10x PCR buffer contains: 500 mM KCl; 100 mM Tris-HCl (pH 8.3); 15 mM MgCl2 (the final concentrations of these ingredients in the PCR mix are: 50 mM KCl; 10 mM Tris-HCl; 1.5 mM MgCl2).
QUESTIONS and SOLUTIONS
1. I get (many) longer unspecific products. What can I do?
Decrease annealing time Increase annealing temperature Decrease extension time Decrease extension temperature to 62-68º C Increase KCl (buffer) concentration to 1.2x-2x, but keep MgCl2 concentration at 1.5-2mM. Increase MgCl2 concentration up to 3-4.5 mM but keep dNTP concentration constant. Take less primer Take less DNA template Take less Taq polymerase If none of the above works: check the primer for repetitive sequences (BLAST align the sequence with the databases) and change the primer(s) Combine some/all of the above
2. I get (many) shorter unspecific products. What can I do?
Increase annealing temperature Increase annealing time Increase extension time Increase extension temperature to 74-78º C Decrease KCl (buffer) concentration to 0.7-0.8x, but keep MgCl2 concentration at 1.5-2mM Increase MgCl2 concentration up to 3-4.5 mM but keep dNTP concentration constant Take less primer Take less DNA template Take less Taq polymerase If none of the above works: check the primer for repetitive sequences (BLAST align the sequence with the databases) and change the primer(s) Combine some/all of the above
