Method: Essentially that described by Heins et al. (1966) based upon the release of acid soluble oligonucleotides following nuclease digestion of DNA. One unit corresponds to a change in optical density of 1.0 at 260 nm at 37°C and pH 8.0 under the specified conditions.
Reagents
0.1 M Sodium borate, pH 8.8
0.01 M Calcium chloride
DNA, 2.5 mg/ml: prepare by dissolving 25 mg Worthington Calf Thymus DNA in 10 ml 0.01 M NaCl. Allow to stand overnight at room temperature and then stir slowly to effect solution.
7% Perchloric acid
0.1% Bovine serum albumin
Enzyme
Dissolve at one mg/ml in reagent grade water. Dilute for assay to 0.001-0.002 mg/ml in 0.1% albumin.
mgP/ml=A280*1.07
Procedure
Into each of 5 numbered test tubes pipette as follows:
| 0.1 M Sodium borate, pH 8.8 | 0.1 ml |
| 0.01 M CaCl2 | 0.05 ml |
| 0.25% DNA | 0.1 ml |
Incubate in 37°C water bath for 6-7 minutes to achieve temperature equilibration. Prepare a minimum of four different dilutions of enzyme in the range of 0.001-0.0002 mg/ml. At timed intervals pipette 0.1 ml of appropriate dilution into respective tubes and replace in the water bath. To the fifth, which will serve as a blank, add 0.1 ml of 0.1% albumin. Incubate for 30 minutes. Stop the reaction at timed intervals by adding 0.5 ml 7% perchloric acid. Place the tubes in an ice bath for 10 minutes, then add 2.7 ml reagent grade water. Centrifuge for 15 minutes at highest speed on a clinical centrifuge. Withdraw clear supernatant and read A260 versus the blank.
Note: For best results, sample should be diluted so that the final A260 falls between 0.2-0.9.
Calculation
A260(Sample)-A260(Blank) Units/mg = ---------------------------- mg enzyme in reaction mixture
